Design House 545814 Installation Guide download pdf (Page 1)

House

Design

Place gasket on bottom of new faucet. If sink is

uneven, use silicone under the gasket.

Connect the water supply lines.Stainless steel braided

faucet supply tubes with ½” female IPS connection or

flexible supply lines with 3/8” OD and coupling nuts will

work. Match the opposite end to your water supply fittings

or shut off valve under your sink. Carefully follow the

manufacturer’s installation instructions for each tube. Note:

when looking at the faucet the left pipe is the Hot water

side, the right pipe is the Cold water side.

Re-assemble aerator,

but do not overtighten

Remove flange (1) and rubber washer (2). Screw

rubber washer (3) plastic washer (4) and mounting nut (5)

down onto pipe body. Put the rubber washer (2) and

flange (1) into the sink hole. From underneath sink screw

the pipe body into the flange. Make sure the nut is facing

the faucet (pointing towards back of sink). Push the

rubber washer (3) and plastic washer (4) tight against the

flange. Tighten mounting nut (5) against rubber washers

using a wrench to create a water tight seal.

7. Install the spring clip on the ball rod, and simultaneously

insert the linkage (2).

8. Insert lift rod (1) into back of faucet, through the linkage

hole. Tighten the lock nut (2). Pull the lift rod knob up and

down and move the linkage along the ball rod to the optimal

location.

plastic

washer

Wrap threaded connections (except aerator thread in spout or where o-ring

or rubber sealant are present) with Teflon tape available from your local

hardware or plumbing supply store. Always wrap in a clockwise direction.

When installing your new faucet, first hand tighten the connector nuts, then

use one wrench to anchor the fitting and a second wrench to tighten the nut

one additional turn. Connections that are too tight will reduce the integrity of

the system.

Warning! Avoid contact of plastic parts with plumber’s putty, pipe dope, or

any other oil based compound. Use a silicon, acrylic, or latex based

sealant where needed.

Handle

Screw

Color button

Adjusting nut

Cover

Block

Ball valve seal

Ball valve

Lock nut

Panel

Sealing gasket

Sealing spring

O-ring

Spout

Washer

Aerator

Aerator shell

Copper tube

Plate

Stator

Bolt

Mounting nut

Washer

Body

Pop-up

Stator

Screw

Coupling nut

MIDDLETON SINGLE

HANDLE LAVATORY FAUCET

WITH POP-UP DRAIN

Models 545830, 545814, 545822

Summary of Contents

Page 1 - WITH POP-UP DRAIN

HouseDesign Place gasket on bottom of new faucet. If sink is uneven, use silicone under the gasket. Connect the water supply lines.Stainless st

Comments to this Manuals

No comments

Design House 545814 Installation Guide Page 1

Browse online or download Installation Guide for Sanitary ware Design House 545814. Design House 545814 Installation Guide User Manual

Summary of Contents

Comments to this Manuals